Log in or create an account
November 06, 2014
Written by John Folger
I’ve just finished build and configuration of i3.
But I have an issue maybe if possible you can point me to right direction for investigation.
I am using mac. In repetier when I click home all all motors goes to its end stops. When I start printing extruder and bed heated to desired temp and printing head goes down to surface to start print but in the same time bed tries to go out of the end point, it hits y endpoint again and again.
I’ve mounted endstops as pointed in instruction (y endstop located at front of frame).
Do you have any idea what it may be?
With best regards,
Comments have to be approved before showing up.
Copyright, Folger Technologies 2015
POS and Ecommerce by Shopify
Payment methods we accept